Home > LPG Gas Products >

45 Degree LPG Fitting 1/4" x 3/8"
45 Degree LPG Fitting 1/4" x 3/8"
 
Our Price: £19.91 Exc VAT


Product Code: GF.Z1181

OEM No# or Image for Reference Only
 
OEM No# or Image for Reference Only
  • What is difference between NPT and BSP thread?
  • However, the designs of the threads differ in two fundamental ways. With NPT, the peaks and valleys of the threads are flat. In BSP, they are rounded. Secondly, the NPT angle of the thread is 60 degrees and the BSP angle is 55 degrees.
  • BSP Threads
  • British standard pipe fittings are amongst the most popular threads in the world today.
  • Here is how to identify a BSP thread.
  • BSP threads come in two different variants:
  • Parallel (BSPP)
  • Tapered (BSPT)
  • The thread flank angle for both tapered and parallel British threads is 55°.
  • It is fairly common for a tapered BSP thread to be mistaken for an NPT thread. The way to tell the difference between the two is the flank angle.
  • The flank angle for NPT is 60° compared to the BSP tapered which is 55° (this can be verified with a thread gauge).
  • BSP threads are measured in imperial measurements such as 1/8, 1/4, 1/2, 3/4 etc.
  • BSP parallel threads commonly seal via a 30° chamfer on the male thread to a 30° recessed cone inside the female thread (swivel only).
  • If it is a port application an o-ring and a washer or bonded washer are needed to achieve a proper seal for parallel threads.
  • For tapered BSP threads, a seal is acquired via thread wedging with additional support from thread dope or Teflon tape.
  • As previously mentioned, it is possible for a male BSPT (tapered) to fit into a female BSPP (parallel), so long as the female thread is fixed and not swivel (this is due to the recessed cone seat).
  • BSP parallel thread size fittings and their specifications can be identified by completing a few calculations.
  • To find the thread size:
  • 1) Measure the O.D (Outer diameter) of the BSP thread.
  • 2) Take the O.D measurement in inches and subtract 1/4 (.25″).
  • For example, a BSP parallel male thread measures out to O.D 1″.
  • Subtracting 1/4 gives a thread size of 3/4 also known as “dash” 12.
  • Once you have the thread size, you then need to determine the number of threads per inch to verify that it is a BSP fitting.
  • You can do this by counting the number of thread crests over a 1/4″ length and then multiply this by 4 to get the number of threads per inch.
  • For example, if over a distance of 1/4″ you have 3.5 thread crests:
  • 1) Multiply 3.5 by 4 to get 14. This is the number of threads per inch
  • 2) Combine the thread size with the number of threads per inch and refer them to the following chart to find your desired size and its relative specifications.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

LPG Gas Products